Zone Controller (USB)

Order code: BBSP-ZC/U

 

A wireless interface that talks to other Enistic products and sends the information via a USB connection to Enistic Energy Manager or Enistic Energy Manager Lite

  • Acts as the interface between Enistic products and Enistic software
  • Can handle up to 50 concurrent connections from Smart Sockets, Smart Meters, switches, etc
  • Ultra-long range (mesh networking gives full coverage of an office or home with just one Zone Controller)
  • Plug and play interface to Enistic Energy Manager
  • Cost effective

To buy, please call us on 0844 875 1600 or email us.

The Enistic Zone Controller acts as a master interface between the Enistic Energy Manager and other Enistic products. With a simple plug and play fitting, this controller is ideal for simple installations and / or trials and energy audits.

Because Enistic is a meshing system, every module talks to every other module in order to maximise range and reliability. This means that in any office or home environment, only one USB Zone Controller is required for full coverage so long as every module is within 30m of any other module. If the Zone Controller cannot directly pass messages to any module on the network, the other modules in the range will "pass on" the message to ensure 100% operation.

Specifications

  • USB bus powered.
  • Supports Low power Modes
  • USB 2.0 Full Speed Device, backwards compatible to USB1.1 hosts
  • Form factor: USB Stick L80mm x W26mm x H8.5mm
  • Operating Temperature range -400C - +850C.

Software

  • Drivers are pre-installed for the USB controller

Technical

  • 2.4GHz ISM Band digital direct sequence spread spectrum transceiver
  • Hardware acceleration for IEEE802.15.4 operations
  • Hardware supported encryption (AES-128)
  • Pre-programmed as a ZigBee coordinator and router
  • Ideal for use as a commissioning tool when setting up networks.